ICIMACS for DANDICAM: IC/IR Hardware Startup Procedure

7/23/98 : JAM

(ICIMACS = Instrument Control and Image Acquisition System

DANDICAM IC/IR Startup Procedure:

If the external SCSI cable is connected between the IC/IR and another computer, both computers should be started at the same time, or both machines may not be able to use their shared SCSI disk.

1) Check that the cables behind the IC/IR correspond to their labels on the IC/IR case

2) Turn on the IC/IR (and any other computer connected to it). Make sure both of its monitors are on. Let it run until it reaches the DOS prompt, or the IC/IR program starts. If you are at the DOS prompt, type the instrument name to start the program. Wait until you get the instrument name prompt at the bottom of the screen.

3) There is now a row of status "lights" on the monochrome monitor, between the status window and the command window. Their nominal values vary from instrument to instrument, so check the start up procedure for the particular instrument you are using.

Remember: The ultimate fix is simply to restart.

Imaging Sciences Laboratory
Revised: July 23, 1998 [jam]