ICIMACS for DANDICAM: Startup Procedure

3/24/00 : JAM


Turn the HE (head electronics, the big silver box) on, if it is not already
Turn the IE (instrument electronics, the smaller red box) on, if it is not already
Power on the WC and wait until it reaches the DOS prompt (C:\WC>)
Power on the IC and wait until it reaches the DOS prompt (C:\ANDICCD>)
Power on the IR and wait until it reaches the DOS prompt (C:\ANDIIR>)
Turn the WC off, then back on again. Wait until it reaches the DOS prompt
At the WC prompt, type "WC" and press enter
Wait until the WC reaches the "WC%" prompt
On the IC, type "IC" and press enter
Wait until the IC reaches the "ANDICCD%" prompt
On the IR, type "IC" and press enter
Wait until the IR reaches the "ANDIIR%" prompt
Type "STARTUP" on prospero.
If prospero reports that startup cannot be completed due to errors, follow the instructions given by prospero, or see the DANDICAM software notes for suggestions, or power down the WC, IC and IR and repeat the instructions above.

Imaging Sciences Laboratory
Revised: March 24, 2000 [jam]